Brian, is that you?I just had two bowls of chilli with onions and jalapeños, I can plug that sucker up
Thanks for your generous offer. But I'm set. Its all part of helping the INGO family.Cameramonkey and jamin each win a box of ammo pm me with preferred calibers..
Make it something I already have!
I have most common calibers.
Do you think a little bit of silicone around the rubber would be overkill? Call it "extra insurance".Sorry I missed the same suggestion earlier. That’s how I would fix it. Licensed plumber here for what it’s worth.
That i will do.Thanks for your generous offer. But I'm set. Its all part of helping the INGO family.
And if you REALLY want to be generous, stick a bit extra in the collection plate tomorrow.
Do you think a little bit of silicone around the rubber would be overkill? Call it "extra insurance
I wouldn’t put any silicone on the rubber, but I would run a bead around the outer part of the plug to seal it to the stool flange.Do you think a little bit of silicone around the rubber would be overkill? Call it "extra insurance".
I appreciate the offer. I have to also decline. I would, however, appreciate it if you could find a 4-h club or youth club that could use some 22s. Send them a box for me.Cameramonkey and jamin each win a box of ammo pm me with preferred calibers..
Make it something I already have!
I have most common calibers.
I can do that too.I appreciate the offer. I have to also decline. I would, however, appreciate it if you could find a 4-h club or youth club that could use some 22s. Send them a box for me.
But why? The proper fix is under $10 with tax. And probably gas money to and fro.Duct tape cut about 24” long then rip them lengthwise into two pieces. Stick the two pieces together (sticky sides together), and then make a loop, tape together with more duct tape. Next take a cordless drill and put one end of the loop under the nut of the clamp and the top end of the loop over the chuck of the drill. Use the variable speed of the drill to spin the nut of the clamp. It might not get it as tight as a proper nut driver/socket/screwdriver but it should get it tight enough.
No offense was intended. Just asking why trip over dollars to pick up quarters?It was just an idea.
I wasn’t aware you had closed the thread.