Pistol custom frame work

[BioCrypto]

I’m looking for somewhere within reasonable driving distance to have some custom pistol frame work done. I’m looking at getting a dual undercut put on a Glock 19. I’m around the Ft Wayne area. I’d like not to mess with shipping is the reason I ask. Thanks all.

 

[TJ Kackowski]

ummm ... isn't a Glock 19 a polymer frame? Break out your dremel or sandpaper wrapped around a wooden dowel and get to it ... you don't need to pay anybody to work on a polymer frame.

 

[55fairlane]

Jerry Johnson in 'busco is good, but I honestly think you should contact our own @AllenM one seriously good pistol guy

 

[bwframe]

I would never again buy a cut on Glock. It kills the resale value.

The best shooters in the world shoot Glocks as they come from the factory. You and I can too.

 

[gassprint1]

I would never again buy a cut on Glock. It kills the resale value.

The best shooters in the world shoot Glocks as they come from the factory. You and I can too.

It is a bit amazing how someone spends a few hundred for such work to add something on their gun they want and then decide to sell it and justify all that extra $$$ over what it should sell for.

 

[Aszerigan]

It is a bit amazing how someone spends a few hundred for such work to add something on their gun they want and then decide to sell it and justify all that extra $$$ over what it should sell for.

Gucci Glock playas got stacks.

 

[ditcherman]

I would never again buy a G***k.

FIFY

ETA; OP, sand it down, make it yours!

 

[Indy574]

Do it yourself is my vote. Take your time and it will be fine. Here’s one I did, however it was just a single undercut.

 

[Paul 7.62]

Look at all them fancy Staple Guns!