So.. what are you reloading at the moment??

[Abominator]

Today is time to start tearing through my Black Friday purchases. I switched bullet size and powder from my last 1k round run of 9mm.

147grn FP SNS
3.2grns of Sport pistol
Federal primers
Mixed range brass

 

[cmann250]

I bought more primers and powder, so I’m back to loading 9mm. So far I’m liking Sport Pistol, even though I’m not using coated bullets. It meters well and seems to burn clean.

124gr FMJ
4.4gr Sport Pistol
Win primer
Mixed brass

Now I’m waiting on a chronograph. These should make minor, but I need to make sure before I load a few thousand.


Sent from my iPhone using Tapatalk

 

[sugarcreekbrass]

Last night I set up 380 dies. First time doing them. I made up a test batch of 100gr Berry's with 2.8 gr of TiteGroup. This will be for a SW EZ.

 

[JStang314]

Tested a few .40 s&w loads and decided on 5.7 gr cfe pistol with 180 gr XTPs. Going to load a couple hundred. G23 and the AR pistol both liked the test loads.

 

[straight-shooter]

45/70
Hand Cast 395gr Powder coated
40.4gr H4895

300 Blkout
Speer 125gr TNT
17.5gr IMR 4227

Going to start loading and testing IMR 3031 for the 45/70 tomorrow

 

[cmann250]

More 9mm, same sport pistol load. Here’s to hoping Santa brings me a chronograph because I suspect I could back this load down a tenth or two and still make minor.

FYI to the 300blk loaders, Midsouth has good deals on 30 cal blem bullets.


Sent from my iPhone using Tapatalk

 

[Leadeye]

32 S&W Long using 105 grain RN cast.

 

[red_zr24x4]

Got some 9's and 38's in the tumbler i shot today.
Need tp finish up about 100 9's then switch over to 38

 

[sugarcreekbrass]

The .380s shot well so now I get to make up more of that. I also just made up some .45ACP to test in the new to me Springfield Loaded I just bought from Trigger Time. Will be loaded up a bunch of those if they work.

 

[Goodcat]

I cleaned and annealed about 300 .308 brass for a buddy, then decapped 350 6.5 cm brass. Gotta fire 50 more, then I’m ready to clean, anneal, etc etc preparing for another trip of 1,000-1,760 yard goodness.

 

[cmann250]

More 9mm, same sport pistol load. Here’s to hoping Santa brings me a chronograph because I suspect I could back this load down a tenth or two and still make minor.

The chronograph does not lie. I’m sending 124gr FMJ bullets out of a 5” barrel.

Still using Sport Pistol, 10 shot average.

4.6gr 1159 FPS 143 PF

4.4gr 1108 FPS 137 PF

4.2gr 1087 FPS 134 PF

So I loaded 4.0gr, 3.8gr, and 3.6gr ladder loads to try tomorrow.


Sent from my iPhone using Tapatalk

 

[red_zr24x4]

Finished up a couple 100 9mm I had, which finished up the 1000 rds I've been piddling with.
Started on the 38's, I had a coffee can of those to do, about 1/2 done.

 

[cmann250]

4.0gr of Sport Pistol will do it.

1036 FPS 128 PF

Now to set the powder measure and crank them out.


Sent from my iPhone using Tapatalk

 

[Fullmag]

Loading 45acp, 200 grains SWC and 4.7gr of WST to 5.3 grains of Bullseye. I didn’t have to adjust powder measure one bit. Never would have thought that be possible.

 

[red_zr24x4]

On a roll tonight, finished the 38's and switching to 45colt. About a 1/2 of a coffee can of them to do

 

[emsdial911]

338 Lapua

 

[cmann250]

I’m done with 9mm for 2020. Made a (3) 30 cal ammo cans plus (10) 100 round plastic boxes over the past 10 or so days. All 124gr/Sport Pistol loads.

On to 45acp after I lube the press.


Sent from my iPhone using Tapatalk

 

[Leadeye]

357 mag using really old components, need to get this stuff used up. Powder is still in a Hercules can.

 

[red_zr24x4]

357 mag using really old components, need to get this stuff used up. Powder is still in a Hercules can.

Loading some 45colt with red dot in a cardboard can

 

[Trapper Jim]

30-30. Case trimming with my New Lyman Case Trimmer express. Very nice and accurate.