Gen 5 Glock 20?

[DadSmith]

In your case it makes sense to get a Gen5.

Holding 1911


Holding the full size PSA Dagger
my little finger is mostly on the grip, but you can see the line on my finger where the grip stops.


Holding my CZ P10F it fits my hand perfectly.

 

[DadSmith]

I want the gen 5. I don't want the grip rash. If I get one I'll have the texture doctored up. That aggressive texture and jackhammer gun, ouch. So that's my work around, have it sanded off.

I mean, did they actually put some rounds through it without gloves on.

My CZ P10F had aggressive texture. I fixed it by putting rubber on it. You can see it in the photo above.

Edit:
I used rubberized anti slip tape you put on steps etc, and a heat gun.

 

[Sigblitz]

Instead of sanding the rifle texture off consider putting a rubbery grip tape like those from Talon grip. It gives good grip while protecting your hand from the rough grip texture of the frame.

Good idea. I have one for the 19/22 frame somewhere so I've used it before on my gen2. I can try it out on my rtf 22.

 

[mousegun87]

Holding 1911
View attachment 247885

Holding the full size PSA Dagger
my little finger is mostly on the grip, but you can see the line on my finger where the grip stops.
View attachment 247886

Holding my CZ P10F it fits my hand perfectly.
View attachment 247887

No kidding! You have a big hand!

 

[mousegun87]

Good idea. I have one for the 19/22 frame somewhere so I've used it before on my gen2. I can try it out on my rtf 22.

I used the grip tape on my Gen3 17 & 19 to add more texture. But I also used the grip tape on my Gen4 to tone the texture down a bit. Another rough grip that I mitigated using a grip tape is the Kahr CW45.

 

[DadSmith]

https://smile.amazon.com/gp/aw/d/B00I511BDQ

This is what I've been using. It's working good. The heat gun really makes it take hold.

 

[mousegun87]

@DadSmith I remember seeing a video on youtube about reliability issue with the G20 gen5. Have you seen this?

 

[Route 45]

Have you seen this?