This mornings project was deleting roll marks from Springfield Champion and blending comp sides. I need to do this first So I can clamp this assembly in my mill vise for other cutting.
Feel free to make fun of me grinding first side of the slide with frame installed but Comp is tight and i want to make sure it is indexed where is it will when it is assembled so... there you go.
Not so level ...yet
Now I will remove the slide and flip it over since this side of the comp is flush with the slide
I did not post pics of the height diference between the comp and the slide but there is about .010 width difference per side that I took off the comp before touching the slide
getting there
Now I will flip everything upside down in the mill and blend the front slide cut to the comp
Feel free to make fun of me grinding first side of the slide with frame installed but Comp is tight and i want to make sure it is indexed where is it will when it is assembled so... there you go.
Not so level ...yet
Now I will remove the slide and flip it over since this side of the comp is flush with the slide
I did not post pics of the height diference between the comp and the slide but there is about .010 width difference per side that I took off the comp before touching the slide
getting there
Now I will flip everything upside down in the mill and blend the front slide cut to the comp