jlwest1213
Plinker
Located in Greensburg, Indiana.
Brand new, never fired custom AR15 I have put together (I collected parts through last few months, local gun shop professionaly built). It has a Seekins forged lower, which takes and drops magazines perfectly, YHM Upper Receiver, Centurion Arms CHF barrel, Cross Machine and Tool M16/full auto bolt carrier group, LWRC Nickel Boron enhanced fire control group single stage (trigger. hammer, disconnector), Seekins enhanced magazine release, mil spec carbine buffer tube, Troy 13" Alpha free float fore arm (with accessory rails-2 short and 1 long), and I will include one flat dark earth magpul 30 round pmag.
The Centurion Arms barrel, is 14.5" cold hammer forged mid length gas, chrome lined 5.56/.223 barrel with a permanently attached smith vortex flash hider (professionaly done by Steve at Adco Firearms). Making it a legal, non-nfa firearm. Also has CA's low profile gas block. These barrels are very durable and accurate.
From Centurion Arms' site-
M4 extended feed ramp
1:7 right hand twist with 5.56 Chamber
taper bore
HP/MPI tested
Extra thick Chrome lining
Mil Spec Phosphate finish
***Service life three times a standard barrel***
-1lb, 5.1oz Stripped / 1 lb, 7.1oz with pinned Centurion Arms gas block
1lbs 7.6oz/with gas block 1lb 8.8oz/with FSP 1lbs 12.3oz
The only thing used, is the stock that I had laying around from when I was in the military. I built this up for a friend that can't afford it and it's in my way in the safe. Everything else is brand new. My asking price is what I have into the rifle, and i'm losing a little by throwing in a pmag.
$1,300, OBO
Brand new, never fired custom AR15 I have put together (I collected parts through last few months, local gun shop professionaly built). It has a Seekins forged lower, which takes and drops magazines perfectly, YHM Upper Receiver, Centurion Arms CHF barrel, Cross Machine and Tool M16/full auto bolt carrier group, LWRC Nickel Boron enhanced fire control group single stage (trigger. hammer, disconnector), Seekins enhanced magazine release, mil spec carbine buffer tube, Troy 13" Alpha free float fore arm (with accessory rails-2 short and 1 long), and I will include one flat dark earth magpul 30 round pmag.
The Centurion Arms barrel, is 14.5" cold hammer forged mid length gas, chrome lined 5.56/.223 barrel with a permanently attached smith vortex flash hider (professionaly done by Steve at Adco Firearms). Making it a legal, non-nfa firearm. Also has CA's low profile gas block. These barrels are very durable and accurate.
From Centurion Arms' site-
M4 extended feed ramp
1:7 right hand twist with 5.56 Chamber
taper bore
HP/MPI tested
Extra thick Chrome lining
Mil Spec Phosphate finish
***Service life three times a standard barrel***
-1lb, 5.1oz Stripped / 1 lb, 7.1oz with pinned Centurion Arms gas block
1lbs 7.6oz/with gas block 1lb 8.8oz/with FSP 1lbs 12.3oz
The only thing used, is the stock that I had laying around from when I was in the military. I built this up for a friend that can't afford it and it's in my way in the safe. Everything else is brand new. My asking price is what I have into the rifle, and i'm losing a little by throwing in a pmag.
$1,300, OBO
Last edited: