Hello!
I have a simple question out of curiosity: Most of the pistols I see needs a replacement barrel for threading to accept a suppressor, because the slider and barrel ends evenly. But I see that the Beretta 92FS has a small part of the barrel sticking out, so I wonder, can I just take a Beretta 92FS' factory included barrel and just thread it, or that "sticking" part is not enough for accepting a suppressor can?
On the other hand, if I dont have access to order extended barrels, is it OK on a Glock 17 just use a Glock 34 barrel? Do I need special instructions on this? Does the Glock 34 barrel fits the Glock 17 without any modification?
Thanks a lot! Great forum!
I have a simple question out of curiosity: Most of the pistols I see needs a replacement barrel for threading to accept a suppressor, because the slider and barrel ends evenly. But I see that the Beretta 92FS has a small part of the barrel sticking out, so I wonder, can I just take a Beretta 92FS' factory included barrel and just thread it, or that "sticking" part is not enough for accepting a suppressor can?
On the other hand, if I dont have access to order extended barrels, is it OK on a Glock 17 just use a Glock 34 barrel? Do I need special instructions on this? Does the Glock 34 barrel fits the Glock 17 without any modification?
Thanks a lot! Great forum!