I have for sale a stripped Anderson lower and a complete Anderson upper without a BCG or charging handle. The upper was assembled using mil spec aeroshell 33ms grease, 6 pin spikes barrel nut wrench and a torque wrench to ensure everything is within spec. Everything used was purchased new. I started this project as a pistol build but decided I would like to go a different direction. Only parts needed to finish this build would be a bcg, charging handle, buffer tube kit and lower parts kit. Below are the parts used in the upper...
- Noveske 8.5" 5.56 stainless barrel
- Factory pinned Noveske low profile gas block
- Pistol length Noveske gas tube
- Noveske flaming pig KX3
- Spikes Tactical BAR 10 inch handguard
SOLD
Buyer of this firearm must be willing to sign a simple bill of sale for both of our personal records stating that you can legally own a firearm in the state of Indiana. Buyer must also show at least an Indiana drivers license, preferably an Indiana carry permit if you have one. Buyer must be willing to meet in Fort Wayne.
- Noveske 8.5" 5.56 stainless barrel
- Factory pinned Noveske low profile gas block
- Pistol length Noveske gas tube
- Noveske flaming pig KX3
- Spikes Tactical BAR 10 inch handguard
SOLD
Buyer of this firearm must be willing to sign a simple bill of sale for both of our personal records stating that you can legally own a firearm in the state of Indiana. Buyer must also show at least an Indiana drivers license, preferably an Indiana carry permit if you have one. Buyer must be willing to meet in Fort Wayne.
Last edited:
