TRADED
This started out as a project gun that I was planning on carrying. During the project timeline, I acquired an Ed Brown that took its place. A lot of time hand fitting and money wrapped up in this pistol. Slide fit has no side to side movement and it shoots well. There are less than 300 rounds down the barrel. It’s a very nice shooter.
TV $1,000
This beauty started its life in 2007 as a forged stainless steel Champion with 4” barrel. During the project, the following was completed or upgraded.
Looking to trade for 9mm 1911 or other hammer fired 9mm pistols that are metal framed.
Message with questions or offers. I’m open to all offers but many looking for trade interests above.
This started out as a project gun that I was planning on carrying. During the project timeline, I acquired an Ed Brown that took its place. A lot of time hand fitting and money wrapped up in this pistol. Slide fit has no side to side movement and it shoots well. There are less than 300 rounds down the barrel. It’s a very nice shooter.
TV $1,000
This beauty started its life in 2007 as a forged stainless steel Champion with 4” barrel. During the project, the following was completed or upgraded.
- Frame, slide and magwell black oxide coated. (Finish was completed at the same shop that does ACW & Cabot).
- EGW magwell, lightened hammer, tactical thumb safety, full length guide rod kit, sear, and disconnector.
- Ed Brown slide stop, extended magazine release, and rear sight.
- 10-8 Performance flat trigger (4# pull).
- Wilson Combat bullet proof extractor, ejector, firing pin, firing pin stop, pin set, and 8 round magazine
- Trijicon HD front sight.
- Lok Grips Crosscut black/od green grips.
Looking to trade for 9mm 1911 or other hammer fired 9mm pistols that are metal framed.
Message with questions or offers. I’m open to all offers but many looking for trade interests above.
Attachments
Last edited:
