dieselrealtor
Master
went out to test some loads last night.
The brass was processed & primed by someone else I picked up in a package deal.
All the ones I checked with my Dillon gauge headspaced correctly.
This is what happened to 3 of them, then the bolt was very stiff to get out & had a little difficulty getting the brass out of the chamber.
I did not approach maximum loads, the 2 at top were 24.0 of IMR 4064, the one on the right was 25.2 of the same.
View attachment 44571
I thought about testing the rest of the batch with a little air pressure, 5-10 psi to see if any of the primers are loose, any suggestions?
The brass was processed & primed by someone else I picked up in a package deal.
All the ones I checked with my Dillon gauge headspaced correctly.
This is what happened to 3 of them, then the bolt was very stiff to get out & had a little difficulty getting the brass out of the chamber.
I did not approach maximum loads, the 2 at top were 24.0 of IMR 4064, the one on the right was 25.2 of the same.
View attachment 44571
I thought about testing the rest of the batch with a little air pressure, 5-10 psi to see if any of the primers are loose, any suggestions?