steveh_131
Grandmaster
Looking for a little help from some of you wiring experts.
I'm trying to wire up a fairly old lathe. I put a new (used) AC motor on it, that the specs claim is reversible. I also picked up a cylinder switch to handle forward and reverse switching.
I ran a 4-wire armored cable from the switch to the motor. Looking back, I'm not sure there are enough wires, but you tell me.
Here are some pictures of what I'm working with. I was hoping someone could give me an idea of how I should go about wiring this thing. Thanks in advance for any help!
Plate on the motor:
Motor's wiring diagram:
Motor terminals:
Switch terminals (there are 3 terminals on each side):
I'm trying to wire up a fairly old lathe. I put a new (used) AC motor on it, that the specs claim is reversible. I also picked up a cylinder switch to handle forward and reverse switching.
I ran a 4-wire armored cable from the switch to the motor. Looking back, I'm not sure there are enough wires, but you tell me.
Here are some pictures of what I'm working with. I was hoping someone could give me an idea of how I should go about wiring this thing. Thanks in advance for any help!
Plate on the motor:
Motor's wiring diagram:
Motor terminals:
Switch terminals (there are 3 terminals on each side):