I'm going to upgrade my heavy, mil-spec trigger to something a little better. I know there are threads on this but most are a bit older.
The rifle is used mainly for plinking and punching holes in paper, but the occasional varmint trip happens also.
Post your suggestions with a link too please.
UPDATE------ I bought a takeout factory BCM off an INGO member. It's installed and is a good improvement over the milspec one I had. You can read about it towards the end of this thread.
The rifle is used mainly for plinking and punching holes in paper, but the occasional varmint trip happens also.
Post your suggestions with a link too please.
UPDATE------ I bought a takeout factory BCM off an INGO member. It's installed and is a good improvement over the milspec one I had. You can read about it towards the end of this thread.
Last edited: