4651feeder
Expert
Loaded a few up for 9mm using LEE 4 die set with seating and factory crimp in separate stages. All dies were installed in turret according to LEE's suggested depth. After seating one of the bullets and before performing a light crimp found reason to pull the bullet. I've done this before with other calibers and know how much effort is required or at least thought I did, all I have is an impact/hammer puller. This son of a gun just does not want to pull. I'm not putting a large bell on the case before seating, just the same excessive pressure is not required to seat the bullet. Are powder coated bullets harder to pull by nature or do I have something cranked down too hard on the press?