hornadylnl
Shooter
- Nov 19, 2008
- 21,505
- 63
Here is quick old school drafting print I came up with for building a gunsmithing/ reloading table for my future gun vault. I hope to have it made out of oak. I'll go with 2 layers of 3/4" ply for the top probably and wrap it with oak trim and then put a sheet of rubber on top about 1/4" thick.
The top dimensions will be 4'x8' and 36" tall. There will be a 5' wide by 3' deep drawer that I'll make customer dividers for die boxes, cleaning rods, brushes, etc.
I'll probably have 2 of them made so I can have a dedicated one for smithing and cleaning one and the other for reloading only.
Anybody have any idea what it would cost to make one of these? I don't have the patience or the tools to build these myself. I want them to look nice.
The top dimensions will be 4'x8' and 36" tall. There will be a 5' wide by 3' deep drawer that I'll make customer dividers for die boxes, cleaning rods, brushes, etc.
I'll probably have 2 of them made so I can have a dedicated one for smithing and cleaning one and the other for reloading only.
Anybody have any idea what it would cost to make one of these? I don't have the patience or the tools to build these myself. I want them to look nice.