BOTH GUNS ARE SOLD.
Asking $425 for each, or $800 for the pair.
Both guns are test fired but un-carried and come with 1 mag.
Small amount of wear just from getting bumped around in the safe.
Located in Bloomington, IN. Looking for a FTF sale close by.
Will want to see Indiana DL and LTCH...
I run Henry Holsters in Bloomington, and we also make all the PHLster products. None our standard AIWB or light-bearing AIWB rigs will work with sights that tall, but the PHLster Floodlight should work. You would need to add that X300 to use the holster, but there's quite a bit of sight...
Adding rubber spacers between the layers isn't necessary, but if you want to change the offset/spacing between the GripHook and the ModWing, a thin rubber spacer placed between them can work well.
The GripHook and ModWing were designed here in Indiana, but are manufactured in CA, and owned by Index Fastener.
On your skeleton, you'll have better results (less potential side-to-side movement from the Griphook) if you reverse the hardware and put the screws through from the back, with the...
This isn't the first year we've had the event. A few IUPD guys showed up last year to check it out and stayed to listen until they had to leave on a call.
Cosermann, it's a discussion/concept workshop. If you can sit in a chair without injuring yourself, you can come to this class. Vince, it's IU, which is a designated GFZ. Act accordingly.
My company, Henry Holsters, is sponsoring an workshop for the IU Bloomington chapter of Students for Concealed Carry on Campus this coming Monday, April 18th, from 5:30-7:30pm in the Redbud Room at the IU Memorial Union.
Shay VanVlyman (SHAY here on INGO) will be talking about personal...
Dosproduction,
I think you may have gotten me confused with someone else. Pretty sure I don't have any pending orders from you. Perhaps you meant INGO user HPClayto?
I've never posted up a thread with lots of pictures of my work, but he has posted photos of his.
Sorry that I didn't chime in sooner. Here's my quick rundown on AIWB options.
Tuckable models come with a single strut w/ soft loop. They'll move more with you, but that movement also means that there's a little more variation in the exact location and angle of the grip when you go to draw...
SOLD
This was donated to my church as part of a fundraising drive, and I was asked to sell it since I'm a "gun guy."
It was included in the 700 trigger group recall, and has already been returned to Remington and serviced.
Very clean, about 25 total rounds fired.
Chambered in .308
Nikon...
The holster configuration that iChokePeople is using is a combination of the two different AIWB holsters that I offer. Personally, I prefer a non-tuckable holster that mounts with two snap loops, much like the Archangel. My loop spacing is a little bit different than Dale's, and I angle the...