WTS: South Bend 10L CL187AB (heavy ten) Made approximately 1960 or 1961.

[Backpacker]

Sold pending funds

$1700 Reduced Price

Would consider partial trade for 9mm carbine such as Kel Tec Sub 2000 gen 2. Prefer one that uses M&P magazines.

South Bend 10L CL187AB (heavy ten) Made approximate 1960 or 1961.
1-3/8" hole through spindle. 4 foot bed length. Lathe is wired single phase 220V.
Accessories included;
5C RSB collets 16pcs 1/16 to 1" by 16ths. Hand wheel draw bar, collet nose and spindle thread protector.
8-1/2" face plate, 5-5/8" drive plate, 7 drive dogs.
Steady rest
Follower rest
Taper attachment
6" independent 4 jaw Skinner chuck
6" 3 jaw Cushman chuck with two sets of jaws
Enco quick change tool post with 12 tool holders
Two dead centers
Two live centers
Jacobs 14N super ball bearing drill chuck for tail stock.
[FONT=&amp]Bull gear cover is missing.
Lathe is powered up and available for test run.
Located in Greenwood 46143
[/FONT] [FONT=&amp]
[/FONT]

 

[Backpacker]

$1700 Reduced Price

Would consider partial trade for 9mm carbine such as Kel Tec Sub 2000 gen 2. Prefer one that uses M&P magazines.