So, after waiting over a year, I picked up my mask to discover that one of the baffles was slightly deformed. I contacted DA and they said it would be fine but that I could send it in for a replacement baffle. I did this because I wanted my new suppressor to be right. I waited 2 more weeks and got it back today to find that they replaced the standard baffle with a blast baffle...so now there are two blast baffles. I contacted DA again and they assured me I wouldn't see any performance issues, but I have little faith in the CS rep on the other end of the email just based of the inferred tone I got from his messages and the lack of any information other than stating it would be fine. Can anyone here provide any insight? Am I better off or the same? Should I be sending it back in for them to get it right?
I should have 1 blast baffle and 6 standard baffles then shorter baffle for the other end.
This is the deformed standard baffle and the reason I sent it in.
I should have 1 blast baffle and 6 standard baffles then shorter baffle for the other end.
This is the deformed standard baffle and the reason I sent it in.