Have you reached out to S&W customer service? They should be able to tell you what sight you need and give you the specs on it. They might even send you the parts you need. They have been super helpful in the past.
And this is why we change filters in a regular basis. When you don’t, all the air-born funk in the house sticks to the wet AC coil and ends up suffocating the furnace during the heating season. And don’t try to B.S. the HVAC tech and say you have changed the filter on a regular basis. (Just...
If it were me, I would reconfigure the thermostat for gas heat only and remove the heatpump all together. The wait should only be for a compressor delay so it doesn’t short cycle.
Had one early Sunday morning short cycling and giving a pressure switch fault. Same thing… trap on The old Trane high efficiency was plugged. The condensate sloshing around in the inducer was a dead give away. Cleaned the trap and all was well.
It’s the season. And change your filters! A...
Worked around the house all day. Was putting the gator up and saw a deer I. The neighbors corn field. Grabbed some binoculars and snuck to the back corner of my place where there is a cedar tree/bush and some saplings. Had a nice buck in the field and had a couple does with him. They...
Baker Distributing might have the part, but you need an account. Most supply houses won’t sell to the public for liability reasons. The don’t want YouTube techs blowing up a house from installing a part they sold. Best bet would be Koch Air or Habegger, but you also need an account there. If...
My boss told me about this round after going to Alaska. His nephew has one as his bear gun. It’s an interesting round to say the least. Bill bought a FNX-45 Tactical and sent it out to Rowland for their conversion. What a beast. With 185gr non-bonded JHPs, it will vaporize milk jugs. There...
Randy… tell him you want a Honeywell thermostat. AprilAire makes humidifiers and air filters… I wouldn’t recommend their thermostats. Like Hunter from Lowe’s. They make ceiling fans…. And should stick with that.
Here is one for CM. Springfield base with a Clark 460 Rowland kit installed. AllenM did the hard part… putting it all together. Chen Magwell and grips, new Harrison Design grip and thumb safety, EGW internals. And new Cerakote to make it all come together. It’s a cannon… and CM would be...
These two were bribed in MeatChurch Bird Bath overnight then got a healthy sprinkle of the Texas Sugar before going in the Green Mountain Grill at 275 until they hit 165 internal. There were no leftovers so I guess they were good…. Was kinda hoping to take the remains and make chicken salad.
I have a 20” Howa 1500 HB 308 that is a laser. 5 shot group at 100 that is one ragged hole. Hornady 168 AMAX over 44gr. Varget in Winchester brass with CCI BR primers.