Recent content by mac45

The #1 community for Gun Owners in Indiana

Member Benefits:

  • Fewer Ads!
  • Discuss all aspects of firearm ownership
  • Discuss anti-gun legislation
  • Buy, sell, and trade in the classified section
  • Chat with Local gun shops, ranges, trainers & other businesses
  • Discover free outdoor shooting areas
  • View up to date on firearm-related events
  • Share photos & video with other members
  • ...and so much more!
    1. M

      Hodgdon HS 6 - What Is Your Experience With It?

      My go to powder for 9mm Never used it in anything else
    2. M

      Lost my dad Thursday morning

      Sorry for your loss
    3. M

      Best 357 lee cast mold

      Have had very good luck w/ Lee's 158 RNF, and a light charge of W231
    4. M

      SORTING BRASS—-YUCK!

      If you get the trays, highly recommend you get the .380 plate as well. The wife shoots .380, and sorting her stuff out of the ton of 9mm at my range was a real pain before I added the plate
    5. M

      .22 Caliber Go To bullet for 1:8 twist?

      My rifle likes the 69gr SMK's over a near max load of Varget Tried 68gr Hornady's, they didn't shoot bad, but the SMK's were always a little better. YMMV
    6. M

      So.. what are you reloading at the moment??

      Did some 9mm last night.....prolly finish off the box of bullets then switch to .357
    7. M

      Tomphson Center- Compass .308 winchester

      Picked up a .30-06 a couple months ago. Happy with it so far.
    8. M

      Hornady Progressive, a good first choice?

      If you like Hornady......get the Hornady. I prefer Dillon, but Hornady makes a nice press. Would not recommend a Lee progressive. Not bashing Lee, have a Classic Turret and love it, just have known too many people have too many problems with Lee's progressives.
    9. M

      Reloading for Kids Video

      PM sent
    10. M

      Reloading for Kids Video

      How much brass do you think you will need?
    11. M

      The challenges of AR 15 reloading.

      Sounds like a headspace issue, as in you're not moving the shoulder back far enough when you size 'em. But the intermittent thing is bothersome. Just to be clear..... Factory runs OK in the gun? This is an actual failure to chamber and not a failure to feed? (The round makes it into the...
    12. M

      Anyone enjoy reading books?

      Read quite a bit. Mostly Sci Fi and military history. Working on a John Ringo right now.
    13. M

      Overpressure?

      Haven't dealt with them in a while, but I have bought a ton of stuff from CNC in years past before I reloaded one round or another. Everything I bought was new ammunition, and as far as I know, they didn't do reloads. There's different headstamps in the pic, so obviously these were reloads...
    14. M

      So.. what are you reloading at the moment??

      Working out some loads for the .30-06
    15. M

      Tumbling Question

      Dry = deprime after. Wet (pins or ultrasonic) = deprime before.
    Top Bottom